These are our seed pixel pipe matrix clips. They snap onto PVC or EMT pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used at the start and end of a run, and two clips are used back to back everywhere else. Once the seed pixels are routed through the clips, the clips can then be rotated in our out to keep tension on the wire. If you want to ensure that the clips won't rotate over the season, simply drive a screw through one of the pilot holes on the clip into your pipe. Ensure not to tighten the screw too much or the arm of the clip may break. These are available in a 1in or 2in spacing from the pipe. They are designed for seed pixels with 2" or greater spacing between seed pixels. If you are using 1" seed pixels, a different clip is suggested and is coming soon.
If you need to support your frame from bending while the seed pixels are under tension, we suggest using our perpendicular pipe mounts to support the frame. They can be found HERE.
If you have access to a 3D printer, you can download any of the designs for free by following the links below.
Base bulk pricing will be reflected in your cart and is as follows. Optional configurations are in addition to this base bulk price.
