This is a modified 3D Printed Tombstone brought to you by Your Pixel Store (original design by Gene Euber). Each Tombstone incorporates two (2) P5 Panels to give you animation with pixels in a single prop. To use the P5 Panels you will need 2 outdoor rated panels, a colorlight controller, and a 5v power supply which are all available at Your Pixel Store.
This tombstone is over 33" tall and 24" wide when fully assembled. Your tombstone order will be shipped to you disassembled. Even though the pieces fit nice and snug together, it is recommended to glue all of the pieces together once you have everything assembled and how you prefer it. Each assembled tombstone weighs in at over 6lbs and we recommend using rebar behind the tombstone to secure it in an upright position. Please note that the backer plates for this tombstone will NOT create a watertight seal for your electronics. Consult with Your Pixel Store on the appropriate equipment you should purchase for this prop.
If you have access to a 3D printer, you can download any of the designs for free by following the links below.
