This is an end cap used with the Bullet Track system. Each end cap gives your Bullet Track system a professional finish. There are three variations available for these end caps, a blank end cap, an end cap with a threaded hole for a PG7 gland, and an end cap with a threaded PG9 gland. The PG7 and PG9 glands are also available to purchase. This listing is for the PG7 End Cap only.
These end caps were designed to work with the Bullet Track mounting system offered at YourPixelStore, but these will also work with the track offered from several other vendors such as RGB2Go, HolidayCoro, Wally's Lights and others that use the same dimensions as shown below.
Try Before You Buy:
This option is for those of you that are not certain if this clip will work for you. Feel free to download the file for free and if it works out for you, please consider supporting us by returning and purchasing the file.
Terms & Conditions:
note that by downloading any STL files from our website, you agree to
our Terms & Conditions of use of any downloaded files from our
website.
Recommended Printer Settings:
These are the minimum print settings that we recommend you use
Dimensions:
Length: 50.4mm
Width: 45.85mm
Height: 6mm
Need other accessories for your Bullet Track installation? Check out our other designs that work with the Bullet Track mounting system.
Downloadable STL Files: