EMT Pipe Options

This is our beam mount clip. This is available for 1/2" & 3/4" PVC and EMT pipe. This clip was designed to mount on a beam with standard deck screws and the ability to be rotated 90*. The clip is 15mm thick and 4 inches in length. If you have access...

This is a 3D printed pipe mount that secures to a downspout. There are several orientations of the mount available. This design is simple and only requires the use of a zip tie to securely attach this mount to your downspout. Only two are needed for...

This is an EPMC (EMT Pipe Matrix Clip) that will connect to other EMT pipes to help create a pixel matrix. This version was designed for 1/2" & 3/4" EMT pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to side...

No more icicles flapping in the wind with this flush mount icicle pipe clip! The icicle coro is attached to the pipe of your choice and two holes are in the arm if a zip tie is used to secure the coro to the clip for an even stronger connection. This is...

This is a flush mount pipe clip. This is available for 1/2" & 3/4" PVC and EMT pipe. The mounting hole is a 4mm thru bore with a 6mm diameter counter-bore hole that is 3mm deep. The clip is 15mm thick and varies in length based on the pipe it is made...

This is a 3D printed clip to attach pipe to J-Channel. This is available for 1/2" & 3/4" PVC and EMT pipe. These are available in lengths of 2", 2.5" & 3" and the length is measured from the edge of the J-Channel to the center of the pipe. They are...

This is a 3D printed pipe clip that mounts to a surface with a 1.25" magnet that is to be screwed into the base. These are available in lengths of 1", 1.5" 2", 2.5" & 3". The length is from the center of the pipe to the base of the shaft holding the...

This is our Mini Seed Pixel Tree Base that is used with our Seed Pixel Topper. This base is designed to work with 1/2" & 3/4" EMT or PVC pipes for the pole or the legs. The legs can then use our Perpendicular Pipe Mount to secure them to you mini tree...

This is our Mini Tree Base Tension Hook which is used to connect the seed pixel strands from our Seed Topper to the base ring of your mini tree. There is an eyelet along the back side where a zip tie can be inserted in, and then a second zip zip would...

This is a PPC (Pixel Pipe Clip) that will securely hold a 12mm Bullet pixel parallel to a pipe for Christmas Lights. This was designed for 1/2", 3/4" & 1" schedule 40 PVC pipe, 1/2" & 3/4" EMT pipe and 1/4" round bar. There is also a locking pin option...

This is a PBC (Pixa Bulb Clip) that will securely hold a Pixa Bulb C7 or C9 pixel that can then be mounted to 1/2" or 3/4" PVC or EMT pipe. There is also a locking pin option that will help keep the clip centered on the pipe. A 3mm drill bit is...

This is a PPC (Pixel Pipe Clip) that will securely hold a GumDrop pixel, (round base version) from Your Pixel Store and other vendors, perpendicular to a pipe for Christmas Lights. This was designed for 1/2", 3/4" & 1" schedule 40 PVC and 1/2" & 3/4"...