General STL Files

This is a square pixel mount for 12mm bullet pixels. The mounting holes are 4mm in diameter and the thickness of the base is 8mm. The base is 30mm x 30mm square and a total of 15mm tall.Try Before You Buy:This option is for those of you that are not...

This is a BPTC (Bullet Pixel Tree Clip) that will securely hold a 12mm Bullet pixel parallel to a tree base or branch for Christmas Lights. There are three sizes available that have a different radius to help hug the portion of the tree you are affixing...

This is an angled bracket used with the Bullet Track Mounting system. Each bracket gives your Bullet Track mounting system a professional finish. These angles have a specially designed retention hole for a pixel to be added to the corner if you desire to...

This is an end cap used with the Bullet Track system. Each end cap gives your Bullet Track system a professional finish. There are three variations available for these end caps, a blank end cap, an end cap with a threaded hole for a PG7 gland, and an end...

This is an middle joiner used with the Bullet Track Mounting system. Each joining piece gives your Bullet Track mounting system a professional finish.These end caps were designed to work with the Bullet Track mounting system offered at YourPixelStore, ...

This is an end cap used with the Bullet Track system. Each end cap gives your Bullet Track system a professional finish. There are three variations available for these end caps, a blank end cap, an end cap with a threaded hole for a PG7 gland, and an end...

This is an end cap used with the Bullet Track system. Each end cap gives your Bullet Track system a professional finish. There are three variations available for these end caps, a blank end cap, an end cap with a threaded hole for a PG7 gland, and an end...

This is a surface mounting bracket for a dual power supply. These new brackets were designed for the MEAN WELL LRS-350-5 / LRS-350-12 / LRS-350-24 power supplies. These brackets are 5mm thick with 15mm deep and 53mm wide mounting tabs with dual holes for...

This is a surface mounting bracket for a dual power supply. These new brackets were designed for the MEAN WELL LRS-600-12/ LRS-600-24 power supplies. These brackets are 5mm thick with 15mm deep and 53mm wide mounting tabs with dual holes for varying...

This is a vertical mounting bracket for dual power supplies. These new brackets were designed for the MEAN WELL LRS-350-5/ LRS-350-12 / LRS-350-24 power supplies only. Our vertical power supply mounts are perfect for your P5/P10 panel builds which allow...

This is a generic coro backer plate that is used to keep slitted coro flat. There are three versions of the backer plate available, Single, Dual and Triple zip tie. Each version has a zip tie center to center spacing of two (2) inches. The dual and...