Shop

This is our pipe standoff. This is available for 1/2" & 3/4" PVC and EMT pipe and in lengths of 1" up to 3" in 1/2" increments. The mounting hole is for a 1/4-20 bolt with a 4mm countersunk hole. The clip is 15mm thick and varies in length. If you...

This is a 3D printed gutter clip designed to hold 1/2", 3/4" schedule 40 PVC, PEX or EMT. These clips will latch over the edge of the gutter and hold the pipe or pixel strip securely to the gutter, even in heavy winds! These new clips have a built in...

This is a 3D printed gutter clip designed to hold 1/2", 3/4" schedule 40 PVC, PEX or EMT. These clips will latch over the edge of the gutter and hold the pipe or pixel strip securely to the gutter, even in heavy winds! These new clips have a built in...

This is a 3D printed gutter clip designed to hold 1/2", 3/4" schedule 40 PVC, PEX or EMT. These clips will latch over the edge of the gutter and hold the pipe or pixel strip securely to the gutter, even in heavy winds! These new clips have a built in...

These are our seed pixel pipe matrix clips. They snap onto PVC or EMT pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used at the start and end of a run, and two clips are used...

These are our seed pixel pipe matrix clips specifically for 1" seed pixels. They snap onto PVC or EMT pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used on the top and bottom...

This is a PPC (Pixel Pipe Clip) that will securely hold a GumDrop pixel, (round base version) from Your Pixel Store and other vendors, perpendicular to a pipe for Christmas Lights. This was designed for 1/2", 3/4" & 1" schedule 40 PVC and 1/2" &...

This is a 3D printed Shutter Flush Mount clip PVC or EMT pipe along the top of a standard shutter. These are available in two mounting configurations, a flush mount and a raised angle mount. If you have access to a 3D printer, you can download any of the...

  No more icicles flapping in the wind with this flush mount icicle pipe clip! The icicle coro is attached to the pipe of your choice and two holes are in the arm if a zip tie is used to secure the coro to the clip for an even stronger connection...

This is a 3D printed gutter clip designed to hold 1mm thick pixel strip. This was designed for the HolidayCoro PixNode Classic Strip and Boscoyo ORIGINAL 12mm Pixel/RGB Mounting Strips. These clips will latch over the edge of the gutter and hold the...

This is a 3D printed shingle clip designed to hold 1mm thick pixel strip. This was designed for the HolidayCoro PixNode Classic Strip and Boscoyo ORIGINAL 12mm Pixel/RGB Mounting Strips. These clips will latch onto a shingle and once the pipe is...

This is a 3D printed Pixel Pipe Stake. This was designed to hold the Boscoyo and HolidayCoro pixel strips. They are available in 8", 10" and 12" lengths. When installing these into the ground, it is best to insert a small piece of PVC pipe into the clip...