STL Files

The SFL Drilling Jig is unlike any other jig. This jig is meant to make the drilling process faster, easier and more accurate than any other design. When used properly, a 10' section of pipe can be drilled in less than 10 minutes all while maintaining a...

The SFL Drilling Jig is unlike any other jig. This jig is meant to make the drilling process faster, easier and more accurate than any other design. When used properly, a 10' section of pipe can be drilled in less than 10 minutes all while maintaining a...

This is a square pixel mount for 12mm bullet pixels. The mounting holes are 4mm in diameter and the thickness of the base is 8mm. The base is 30mm x 30mm square and a total of 15mm tall.Try Before You Buy:This option is for those of you that are not...

This is a BPTC (Bullet Pixel Tree Clip) that will securely hold a 12mm Bullet pixel parallel to a tree base or branch for Christmas Lights. There are three sizes available that have a different radius to help hug the portion of the tree you are affixing...

This is a base/wall mount for a Kulp K32A-B. This mount was designed to hold the K32A-B with the Beaglebone Black, but can be used to hold just the K32A-B as well. The mounting posts were designed to use a McMaster Carr Thread-Forming screw number...

This is a wire cover that can be clipped into vinyl siding to capture and/or conceal cables that run to lights, props or other devices. This is available in 1" increments starting at 1" and going as long as 6". The wire channel gap has a 3/8" opening and...

This is a magnetic mount for Coro props. These are available in lengths of 10mm increments starting at 50mm and go up to 100mm to the base of the clip, not including the thickness of the magnet. The round base thickness is not included in that dimension...

This is a middle joiner used with the PermaTrack Pixel Mounting system. Each joining piece gives your PermaTrack mounting system a professional finish. These are the STL files that you can use to print the parts on your own 3D printer. These parts will...

This is a blank end cap used with the Permatrack Pixel Mounting system. Each end cap gives your Permatrack mounting system a professional finish. There are three variations available for these end caps, a blank end cap, an end cap with a threaded hole...

This is an end cap with a threaded hole for a PG7 gland used with the Permatrack Pixel Mounting system. Each end cap gives your Permatrack mounting system a professional finish. There are three variations available for these end caps, a blank end cap, an...

This is an end cap with a threaded hole for a PG9 gland used with the Permatrack Pixel Mounting system. Each end cap gives your Permatrack mounting system a professional finish. There are three variations available for these end caps, a blank end cap, an...

This is a surface mounting bracket for a single power supply. These new brackets were designed for the MEAN WELL LRS-350-5 / MEANWELL LRS-350-12 / MEANWELL LRS-350-24 power supplies. These brackets are 5mm thick with 15mm deep and 53mm wide mounting tabs...