For Permanent Mounting

  No more icicles flapping in the wind with this flush mount icicle pipe clip! The icicle coro is attached to the pipe of your choice and two holes are in the arm if a zip tie is used to secure the...

This is a flush mount pipe clip. This is available for 1/2" & 3/4" PVC and EMT pipe. The mounting hole is a 4mm thru bore with a 6mm diameter counter-bore hole that is 3mm deep. The clip is 15mm...

This is our pipe standoff. This is available for 1/2" & 3/4" PVC and EMT pipe and in lengths of 1" up to 3" in 1/2" increments. The mounting hole is for a 1/4-20 bolt with a 4mm countersunk hole. The...

Our Seed Pixel Command Clips securely hold all types of seed pixels available today, including 3-wire, 4-wire, standard, and XL seeds. These versatile clips can be mounted almost anywhere using small...

Our SeedLink System is a precision‑engineered, 3D‑printed alignment system designed to keep seed pixels perfectly straight, evenly spaced, and structurally supported across any display. Each SeedLink...

This is a 3D printed pipe clip to hold 1/2", 3/4" schedule 40 PVC or EMTpipe that would then mount to a flat surface with two screws. If you have access to a 3D printer, you can download any of the...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These...

This is a 3D printed pipe clip that mounts to a surface at 90* with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip...