STL Files

This is a PPC (Pixel Pipe Clip) that will securely hold a 12mm Bullet pixel parallel to a pipe for Christmas Lights. This was designed for 3/4" schedule 40 PVC pipe. There is also a locking pin option that will help keep the clip centered on the pipe. A...

This is a pipe clip that mounts to a surface with a 1.25" magnet that is to be screwed into the base. These are available in lengths of 1", 1.5" 2", 2.5" & 3". The length is from the center of the pipe to the base of the clip. The magnet thickness is...

This is a vinyl siding corner bracket for 3/4" Schedule 40 PVC. These were designed to fit 3", 3 1/3" and 4" vinyl siding corners.Try Before You Buy:This option is for those of you that are not certain if this clip will work for you. Feel free to...

This is the STL files to print the roof peak brackets designed to hold 3/4" schedule 40 PVC pipe. These brackets will hook over your roof peak top cap and hold the pipe securely to the roof, even in heavy winds!Try Before You Buy:This option is for...

This is a shingle clip designed to hold 3/4" PVC in a perpendicular direction on your roof. These clips will latch onto a shingle and a pipe can then be placed on the clip and secured with a standard zip tie. These clips offer a secure grip in the top...

This is a 3D printed gutter clip designed to hold 3/4" schedule 40 PVC pipe. These clips will latch over the edge of the gutter and hold the pipe or pixel strip securely to the gutter, even in heavy winds! Three different sizes are included in the zip...

This is an PVC to PVC bushing. This bushing was designed to work with the Lasco Schedule 40 fittings. Please note that the 3/4" bushing was designed to fit into a 3/4" Schedule 40 fitting and accept a 1/2"" Schedule 40 pipe.Try Before You Buy:This ...

This is a PPMC (PVC Pipe Matrix Clip) that will connect to other PVC pipes to help create a pixel matrix. This version was designed for 1/2" & 3/4" schedule 40 pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to...

This is a PPMC (PVC Pipe Matrix Clip) that will connect to other PVC pipes to help create a pixel matrix. This version was designed for 3/4" schedule 40 pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to side...

This is our 3/4" PVC pipe standoff. We have included lengths of 1" up to 3" in 1/2" increments in the downloadable files. The mounting hole is for a 1/4-20 bolt with a 4mm countersunk hole. The clip is 15mm thick and varies in length.Try Before You...

These are our seed pixel pipe matrix clips. They snap onto 3/4" schedule 40 PVC pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used at the start and end of a run, and two clips...

These are our seed pixel pipe matrix clips specifically for 1" seed pixels. They snap onto 3/4" schedule 40 PVC pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used on the top...