STL Files

This is a SPPC (Square Pixel Pipe Clip) that will securely hold a 12mm Square pixel to a pipe for Christmas Lights. This was designed for 3/4" EMT pipe. There is a locking pin option that will help keep the clip centered on the pipe. A 3mm drill bit is...

This is a flush mount pipe clip. This is available for 3/4" EMT pipe. The mounting hole is a 4mm thru bore with a 6mm diameter counter-bore hole that is 3mm deep. The clip is 15mm thick and varies in length based on the pipe it is made for. Try Before...

This is a pipe clip that slides onto soffit trim. This is available for 3/4" EMT pipe. The clip is 12mm thick and varies in length based on the pipe it is made for.Try Before You Buy:This option is for those of you that are not certain if this clip will...

This is a PPC (Pixel Pipe Clip) that will securely hold a 12mm Bullet pixel perpendicular to a pipe for Christmas Lights. This was designed for 3/4" EMT pipe. There is a locking pin option that will help keep the clip centered on the pipe. A 3mm drill...

This is a PPC (Pixel Pipe Clip) that will securely hold a 12mm Bullet pixel parallel to a pipe for Christmas Lights. This was designed for 3/4" EMT pipe. There is also a locking pin option that will help keep the clip centered on the pipe. A 3mm drill...

This is a pipe clip that mounts to a surface with a 1.25" magnet that is to be screwed into the base. These are available in lengths of 1", 1.5" 2", 2.5" & 3". The length is from the center of the pipe to the base of the clip. The magnet thickness is...

This is the STL files to print the roof peak brackets designed to hold 3/4" EMT pipe. These brackets will hook over your roof peak top cap and hold the pipe securely to the roof, even in heavy winds!Try Before You Buy:This option is for those of you...

This is a shingle clip designed to hold 3/4" EMT in a perpendicular direction on your roof. These clips will latch onto a shingle and a pipe can then be placed on the clip and secured with a standard zip tie. These clips offer a secure grip in the top...

This is an EPMC (EMT Pipe Matrix Clip) that will connect to other EMT pipes to help create a pixel matrix. This version was designed for 3/4" EMT pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to side spacing that...

This is our 3/4" EMT pipe standoff. We have included lengths of 1" up to 3" in 1/2" increments in the downloadable files. The mounting hole is for a 1/4-20 bolt with a 4mm countersunk hole. The clip is 15mm thick and varies in length.Try Before You...

These are our seed pixel pipe matrix clips. They snap onto 3/4" EMT pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used at the start and end of a run, and two clips are used...

These are our seed pixel pipe matrix clips specifically for 1" seed pixels. They snap onto 3/4" EMT pipe to create wrap locations for your seed pixels. You then use small zip ties to secure the wire to the clips. One clip is used on the top and bottom of...