Build Props, Panels & Matrices

This is an EPMC (EMT Pipe Matrix Clip) that will connect to other EMT pipes to help create a pixel matrix. This version was designed for 1/2" & 3/4" EMT pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to side...

  No more icicles flapping in the wind with this flush mount icicle pipe clip! The icicle coro is attached to the pipe of your choice and two holes are in the arm if a zip tie is used to secure the coro to the clip for an even stronger connection...

These are our P5 Panel joiners for indoor panels. Be sure you select the correct version as the mounting holes are not the same. One easy way to tell is the number of bolt holes on each panel. Typically indoor panels have 6 or eight, and outdoor panels...

This is a magnetic mount for Coro props. These are available in lengths of 10mm increments starting at 50mm and go up to 100mm to the base of the clip, not including the thickness of the magnet. The round base thickness is not included in that dimension...

  These are our P5 Panel joiners for outdoor panels. Be sure you select the correct version as the mounting holes are not the same. One easy way to tell is the number of bolt holes on each panel. Typically indoor panels have 6 or eight, and outdoor...

This is our perpendicular pipe mount. This is a great mount for creating a backer for props beneath arches. These are printed in UV resistant PETG material and if you are concerned with heat in you area, we do offer these in ASA for an additional cost. I...

This is our pipe standoff. This is available for 1/2" & 3/4" PVC and EMT pipe and in lengths of 1" up to 3" in 1/2" increments. The mounting hole is for a 1/4-20 bolt with a 4mm countersunk hole. The clip is 15mm thick and varies in length. If you...

This is a PVC pipe clip to mount to your Coro prop for creating a frame for your Coro prop. Each group of clips can reliably support up to 35lbs of weight as shown in the image. When using EMT, they can hold even more. These are available in lengths of...

This is a front brace for the universal coro mounts. This is used to help distribute the load of the zip tie on the front of the coro as to not damage the coro. These have holes that are one inch apart.   Base bulk pricing will be reflected in your...

This is a pipe to vinyl siding pixel bracket to mount PVC or EMT to your vinyl siding. Each clip can reliably support up to 10lbs of weight. These are available in lengths of 10mm increments starting at 50mm and go up to 100mm to the center of the clip...

This is a PPMC (PVC Pipe Matrix Clip) that will connect to other PVC pipes to help create a pixel matrix. This version was designed for 1/2" & 3/4" schedule 40 pipe. This is available for 1", 1.5", 2", 2.5" and 3" spacing to maintain proper side to...

These are our Roof Prop Mounts for small to medium sized Coro or PVC props. We added holes in the base and feet to secure the PVC with screws so the pipes stay in place while out on your roof. Our mounts have a special knurled texture on the bottom that...