Hang Lights on the House STL Files

Our SeedLink System is a precision‑engineered, 3D‑printed alignment system designed to keep seed pixels perfectly straight, evenly spaced, and structurally supported across any display. Each SeedLink segment features a dedicated pixel channel and...

Our SeedLink System is a precision‑engineered, 3D‑printed alignment system designed to keep seed pixels perfectly straight, evenly spaced, and structurally supported across any display. Each SeedLink segment features a dedicated pixel channel and...

Our SeedLink System is a precision‑engineered, 3D‑printed alignment system designed to keep seed pixels perfectly straight, evenly spaced, and structurally supported across any display. Each SeedLink segment features a dedicated pixel channel and...

This is a 3D printed gutter clip designed to hold 1mm thick pixel strip. This was designed for the HolidayCoro PixNode Classic Strip and Boscoyo ORIGINAL 12mm Pixel/RGB Mounting Strips. These clips will latch over the edge of the gutter and hold the pipe...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a 3D printed pipe clip that mounts to a surface with two screws. The mounting holes are angled slightly towards the center to ensure a power drill does not damage the arms of the clip. These are available in lengths of 2", 3", 4", 5" & 6"...

This is a wire cover that can be clipped into vinyl siding to capture and/or conceal cables that run to lights, props or other devices. This is available in 1" increments starting at 1" and going as long as 6". The wire channel gap has a 3/8" opening and...