SFL Designs

This is a surface mounting bracket for a single power supply. These new brackets were designed for the MEAN WELL LRS-350-5 / MEANWELL LRS-350-12 / MEANWELL LRS-350-24 power supplies.

This is a surface mounting bracket for a single power supply. These new brackets were designed for the MEAN WELL LRS-600-12 / LRS-600-24 power supplies. These brackets are 5mm thick with 15mm deep...

This is a vertical mounting bracket for a single power supply. These new brackets were designed for the MEAN WELL LRS-350-5 / LRS-350-12 / LRS-350-24 power supplies only. Our vertical power

This is a generic coro backer plate that is used to keep slitted coro flat. There are three versions of the backer plate available, Single, Dual and Triple zip tie. Each version has a zip tie center...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for the Baldrick Small, Medium, & Large boards built around the Mean Well LRS‑350 power supply. It gives you a solid, repeatable way to...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for various controller boards built around the Mean Well LRS‑350 power supply. It gives you a solid, repeatable way to mount your controller...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for the Falcon F16 V2, V3, V4, V5 controller or F16 V4, V5 expansion boards built around the Mean Well LRS‑350 power supply. It gives you a...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for the Genius 4 & 16 controller boards and a Raspberry Pi built around the Mean Well LRS‑350 power supply. It gives you a solid, repeatable...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for various controller boards built around the Mean Well LRS‑350 power supply. It gives you a solid, repeatable way to mount your controller...

The SnapMount Pro 350 is a clean, snap‑fit mounting system for the Vivid 8 controller boards built around the Mean Well LRS‑350 power supply. It gives you a solid, repeatable way to mount your...

This is a cable hook that attaches to standard soffit trim. Please measure the thickness of your trim where you plan to attach this and order the correct version. These are available for 1.2mm and 2...

This is a 3D printed gutter clip designed to hold 1mm thick pixel strip. This was designed for the HolidayCoro PixNode Classic Strip and Boscoyo ORIGINAL 12mm Pixel/RGB Mounting Strips. These clips...