Bullet Track Middle Joiner

This is an middle joiner used with the Bullet Track Mounting system. Each joining piece gives your Bullet Track mounting system a professional finish. These joiners are printed with PETG which is UV resistant and are intended to last for many years to come.

These end caps were designed to work with the Bullet Track mounting system offered at YourPixelStore, but these will also work with the track offered from several other vendors such as RGB2Go, HolidayCoro, Wally's Lights and others that use the same dimensions as shown below.

Length: 50.4mm

Width: 45.85mm

Height: 12mm

Need other accessories for your Bullet Track installation? Check out our other designs that work with the Bullet Track mounting system.

• End Caps
• Bottom Hole Angled Corner Bracket
• Middle Joiner

• Inside Corner Bracket (Coming Soon!)

Downloadable STL Files:

• Bullet Track Blank End Cap
• Bullet Track PG7 End Cap
• Bullet Track PG9 End Cap

• Bullet Track Middle Joiner
• Bullet Track 12:12 Angled Corner Brackets