Hang Lights on the House

This is our beam mount clip. This is available for 1/2", 3/4", 20mm and 25mm PVC, 1/2" & 3/4" PEX, and 1/2" & 3/4" EMT pipe. This clip was designed to mount on a beam with standard deck screws and the ability to be rotated 90*. The clip is 15mm...

This is a 3D printed pipe mount that secures to a downspout. There are several orientations of the mount available. This design is simple and only requires the use of a zip tie to securely attach this mount to your downspout. Only two are needed for...

This is a 3D printed pixel strip mount that secures to a downspout. There are several orientations of the mount available. This design is simple and only requires the use of a zip tie to securely attach this mount to your downspout. Only two are needed...

This is a flood light mount used to secure the light to underside of a homes soffit trim. Currently, these are available to be used with 4" gaped soffit. Not all soffit is made to that exact dimension, so it is best to measure the area of soffit these...

  No more icicles flapping in the wind with this flush mount icicle pipe clip! The icicle coro is attached to the pipe of your choice and two holes are in the arm if a zip tie is used to secure the coro to the clip for an even stronger connection...

This is a flush mount pipe clip. This is available for 1/2" & 3/4" PVC and EMT pipe. The mounting hole is a 4mm thru bore with a 6mm diameter counter-bore hole that is 3mm deep. The clip is 15mm thick and varies in length based on the pipe it is made...

  This mount is used with the HolidayCoro PixelPipe(tm) Bullet Style Pixel Node Mounting Pipe to attach it a magnetic surface. They will space the PixelPipe far enough away from the mounting pipe to clear the pixels. The pixel wires will need to be...

Stop battling with icicles that get blown around on PVC pipe. This is our secure mount for handing icicles on your gutters. With this new innovative design, you no longer need to attach your icicles to pipe and then worry about securing the pipe or clip...

  Stop battling with icicles that get blown around on PVC pipe. This is our soffit trim clip for handing icicles from. The clip is 14mm thick and has two holes for zip ties spaced 18mm apart. They have a forward pitch to them to counter the force...

This is a 3D printed clip to attach pipe to J-Channel. This is available for 1/2" & 3/4" PVC and EMT pipe. These are available in lengths of 2", 2.5" & 3" and the length is measured from the edge of the J-Channel to the center of the pipe. They...

This is a 3D printed pipe clip that mounts to a surface with a 1.25" magnet that is to be screwed into the base. These are available in lengths of 1", 1.5" 2", 2.5" & 3". The length is from the center of the pipe to the base of the shaft holding the...

This is a magnetic mount for Coro props. These are available in lengths of 10mm increments starting at 50mm and go up to 100mm to the base of the clip, not including the thickness of the magnet. The round base thickness is not included in that dimension...